【Disassembly】 razer wolverine v2 chroma
Good evening
This time I tried disassembling the junk item of razer wolverine v2 chroma that I got cheaply
I searched the internet and found no information at all, so I tried to find out.
The image will later make the screw position and patchon position stand out.
Suddenly Pakkan!
I wondered if there was a screw on the back seal part, but it's not there.
It is configured to hold the appearance and the base.
As expected it is a luxury item
Basic patchon is quite hard, so let's do it with the momentum to destroy it
I didn`t managed to destroy it.
Even if I think that the screw is finally visible, it still does not come off
The XBox button cover also comes off
Then two screws will come out. 10 screws in all
If you remove it, you can remove the exterior cover on the back side.
It can be easily removed by lifting it from the gap and prying it.
When it becomes a board holding part, there are 3 screws and 2 light guides on the back side and 4 screws.
The cable ties of the LBT and RBT boards will not come off, so be sure to remove the LBRB. The part that seems to be heat-welded on the upper center comes off.
If you remove the button, you will see two screws on the LBT and RBT bases, so just remove them.
And two screws that hold the base
Now you can manage to break it up.
However, it seems that my junk item does not recognize the chip as a controller even though it has 5V.
I gave up the repair.
I don't know if there is demand, but I wonder if I can write an English translation as well.
See you again
